BEHR PREMIUM^™ Spray Paint No. B0012

Preparation

• The surface must be clean, free of dust, grease,wax, peeling paint, mold or mildew. If washing is necessary, use a non-soapy detergent or a TSP substitute. Rinse well and allow to dry.
• †Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. Sanding or removal of paint containing lead is hazardous.
• * Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before painting.

†WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. Contact the National Lead Information Center at 1-800-424-LEAD or log on to www.epa.gov/lead.

empty-paragraph

Application

• Eye protection is recommended.
• For best results, use at room temperature. Cover adjacent areas to protect from overspray.
• Shake can vigorously for 1 minute after mixing ball begins to rattle and often during use. Hold can upright, moving from side-to-side while spraying lightly and evenly about 30 cm from the area being painted. 2 to 3 thin coats produce best results.
• Apply thin coats to avoid runs and sags. Recoat within 1 hour or after 24 hours.
• Dries to touch in 15-30 min. Cooler temperatures or higher humidity may prolong drying time.
• Use Behr^® Primer for enhanced performance on porous surfaces or rough wood.

Clean-up & Disposal

• Clear spray valve immediately after use by turning can upside down and spraying until only clear gas is released. If spray nozzle becomes clogged, remove and clean.
• Do not stick pins or wire into can opening.
• Clean fresh overspray with mineral spirits or paint thinner. Remove dried paint with paint remover, but test small area first to ensure paint remover does not damage substrate
• Please consider donating any unused product. For recycling or disposal information contact your local household refuse collection service.