KILZ^® 3 PREMIUM No. 1300

Preparation†

• All surfaces must be clean, free of dust, chalk, oil, grease, wax, polish, mold and mildew, loose peeling paint, rust and all other foreign substances.
• If washing is necessary, use a non-soapy detergent or a TSP substitute, rinse well and allow to dry.
• Peeling or Checked Paint: Scrape off loose paint and sand to a smooth surface. KILZ® 3 PREMIUM primer is a superior quality, fast drying, low odor, very low VOC, water-based primer-sealer-stainblocker. It has excellent adhesion and provides a mildew resistant coating ideal for moisture-prone areas.*
• †Glossy Surfaces: For maximum adhesion, scuff sand the surface thoroughly before priming.*
• Mold or Mildew Covered Surfaces: Wash the area with a mildew remover, rinse with water and allow to dry before priming.
• Masonry, Brick, Stucco, and Plaster: KILZ® PREMIUM Primer may be used on clean, dry, aged masonry surfaces. New masonry must be allowed to cure (dry) at least 30 days before applying KILZ PREMIUM Primer.
• Fire Restoration: It is critical to clean damaged surfaces thoroughly before priming. Primer recommendations: Water-based primers such as KILZ® RESTORATION or oil based primers such as KILZ® ORIGINAL (interior use).

Application

• Eye protection is recommended. For spray applications, a small amount of water (no more than 1/2 pint per gallon) may be added.
• Do not thin for stainblocking applications. Only apply if surface, air and product temperatures are between 10°-32°C.
• Stir thoroughly before and occasionally during use.
• Brush – High quality Nylon/Polyester.
• Roller – High quality 10-13 mm nap on smooth surfaces or 13-19 mm nap on semi-rough or porous surfaces.
• Airless spray – .017-.021 tip / 60 mesh filter.
• Prime the entire surface to ensure a uniform appearance of the topcoat.
• Stainblocking: After priming, test for stain bleed-through by applying the topcoat to a small section. If the stain bleeds through the topcoat, apply a second coat of primer and test again before topcoating the entire area. If bleeding continues, longer dry time is needed before topcoating.
• Tinting: KILZ PREMIUM Primer may be tinted with up to 60 mL of universal colourant per 3.79 L. Tinting to a lighter shade than the topcoat is recommended.
• Coverage: 28-37 m² per 3.79 L depending on the application method and surface porosity.

Dry Time at 25°C, 50% RH

• Touch in 30 minutes
• Paint in 1 hour

Disposal

• Clean equipment and paint spatters with warm, soapy water.
• Do not dispose of this product down a drain. Please consider donating any unused product. For recycling or disposal information contact your local household refuse collection service.
• If spilled, contain material and remove with an inert absorbent. Dispose of contaminated absorbent, container and unused product in accordance with all current federal, state and local regulations. For recycling or disposal information contact your local household refuse collection service.

To consult with a Behr Company Representative, call 1-800-661-1591.