BEHR® Water-Based Stain & Poly in One No. B6201
BEHR Water-Based Stain & Poly in One delivers rich colour and protection in one easy step. This formula can be tinted to a wide range of popular interior colours and provides a warm look and durable protection to your interior wood surface. This high-performance stain & poly in one dries quick to a uniform finish, allowing you to shorten your project time and achieve beautiful results.
See Our Selection of Interior Water-Based Stains and Finishes
Safety Data Sheets
Finish
Available in Satin and Gloss finish.
Best For Use In
Properly prepared interior surfaces such as furniture, mouldings, cabinets, trim, and wood doors. Do not use on floors.
Coverage
11.6 m2 per 947 ml.
-
Prep
Before Use -
2 Coats
Required -
Spread Rate:
11.6 m2 per 947 ml. -
Clean-Up
Soap & Water
Properly prepared interior surfaces such as furniture, mouldings, cabinets, trim, and wood doors. Do not use on floors.
CAUTION: Surface may be slippery when wet.
PROTECT FROM FREEZING. Do Not Use Without the Addition of Tinting Colourants.
Surface Preparation
Proper surface preparation is required.
FOR STRIPPED, UNSTAINED OR RAW WOOD:
- Before starting, the surface must be dry, clean and free of dirt, grease, and glue.
- Sand the wood in the direction of the grain using fine-grade sandpaper (#150-220 grit) until smooth.
- Remove all sanding dust.
- To help ensure uniform acceptance of stain colour and beautiful results, pretreat new or raw wood with BEHR® Water-Based Pre-Stain Wood Conditioner, following label directions.
FOR PREVIOUSLY FINISHED WOOD THAT IS NOT BEING STRIPPED:
- Before starting, the surface must be dry, clean and free of dirt, grease, and glue.
- Lightly sand the existing finish with 400 grit sandpaper to ensure adhesion.
- Remove all sanding dust.
Read More
PRODUCT PREPARATION AND COLOUR TESTING
- Stir BEHR Stain & Poly In One thoroughly before and occasionally during use. Do not thin.
- Always test Stain & Poly on a scrap piece or hidden area of wood to verify desired colour.
Read More
Application
- Using a high-quality nylon/polyester bristle brush, dip approximately an inch into the can, gently tapping it against the inside to remove any excess.
- Apply a very THIN, even coat following the direction of the grain.
- Make sure to maintain a “wet” edge.
- To minimize the brush marks and bubbles after staining, tip off the surface by holding the brush at a 45-degree angle and lightly run the bristles over the entire length of the wood.
- Let the first coat dry for 1 hour or more.
- Dry time may be extended due to high humidity, low temperatures, and inadequate ventilation or if the coat is applied too thick.
- Lightly sand the surface between coats with fine sandpaper (#400 grit).
- Remove all dust. Brush on a second thin coat following directions above.
- To deepen the colour, apply a third coat.
- NOTE: For additional protection, without adding colour, add a coat of BEHR Fast Drying Polyurethane.
- Please refer to the back label of the container for application instructions.
Read More
Disposal
- For disposal of empty containers and unused product, contact your household refuse collection service.
Read More
To consult with a Behr Company Representative, call 1-800-661-1591.
Read More
Read More
WARRANTY
For one year from the date of purchase, Behr Process LLC warrants to the original consumer purchaser, (1) that the product meets Behr Process LLC’s manufacturing specifications, and (2) the performance of this product when applied according to the label instructions and specifications. If this product is found not to perform as specified on the label within one year from the date of purchase, Behr Process LLC will, at its option and upon presentation of proof-of-purchase (the original receipt), either furnish an equivalent amount of new product or refund the original purchase price of this product to you. The clause of limitation of liability which follows is inapplicable in Québec. THIS WARRANTY EXCLUDES (1) LABOUR AND COSTS OF LABOUR FOR THE APPLICATION OR REMOVAL OF ANY PRODUCT, AND (2) ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, WHETHER BASED ON BREACH OF EXPRESS OR IMPLIED WARRANTY, NEGLIGENCE, STRICT LIABILITY OR ANY OTHER LEGAL THEORY. TO THE EXTENT PERMITTED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE DURATION OF THIS EXPRESS WARRANTY. The above provisions are not intended to operate where prohibited by law. This limited warranty is the only warranty provided by Behr Process LLC unless extended by a provincial consumer statute. To obtain warranty service, call 1-800-661-1591, or contact Behr Process LLC at 110-600 Barlow Square S.E., Calgary, AB T2C 5T7. Behr Process LLC reserves the right to inspect any and all application of the product prior to processing your claim made under this warranty.
Read More
Reviews
PAINTING CONTRACTORS
Professional products and services specifically designed for residential and commercial painting contractors.
FOR CONTRACTORS
PROPERTY & FACILITY MANAGERS
A full range of products and services to help property and facility managers enhance and maintain the appearance of properties.
FOR PROPERTY MANAGERSREADY TO GET STARTED?
CONTACT A BEHR PRO® REP
Your reputation depends on your ability to do the job right. BEHR can help.
Find a rep
JOIN THE HOME DEPOT® PRO XTRA LOYALTY PROGRAM
Get 10% - 20% Back in Quarterly Rewards
BEHR® Paints, Stains & Primers.
About Interior Paint Sheens
Get the look you want and the protection you need for any room in your home.
A flat sheen has a non-reflective finish that touches up well and hides minor surface imperfections.
Low-traffic areas; interior walls and ceilings
Ceilings
Medium-Low
A matte sheen has a low-luster, reflective finish that is durable, easy to clean, touches up well and also hides minor surface imperfections.
Low-traffic areas; interior walls
Family rooms, living rooms, kids' rooms, bathrooms, dining rooms, ceilings
Medium
An eggshell enamel sheen has a soft, velvety appearance that resists dirt and grime, as well as mildew.
Moderate-traffic areas
Family rooms, living rooms, bedrooms, kids' rooms, hallways, dining rooms
Medium
A satin enamel sheen has a pearl-like finish that's easy to clean.
All interior surfaces; moderate- to high-traffic areas
Family rooms, living rooms, bedrooms, kids' rooms, hallways, kitchens, bathrooms, doors, windows, trim, cabinets, shutters, interior furniture
Medium-High
A semi-gloss enamel sheen is sleek and radiant resisting mildew, moisture and wear.
Cabinets and trim; high-traffic, high-moisture areas
Kids' rooms, hallways, kitchens, bathrooms, doors, windows, trim, cabinets, shutters
High
Hi-Gloss enamel sheens provide have a brilliant, shiny appearance and a durable, glass-like finish that allows dirt and grime to be wiped clean.
High-use surfaces
Kitchens, bathrooms, doors, windows, trim, cabinets, shutters, interior furniture
High
About Exterior Paint Sheens
Set the right curb appeal with exterior painting efforts that last.
A flat sheen is non-reflective, and easy to apply and touch up. It will minimize the appearance of minor surface imperfections.
Wood and vinyl walls and siding; brick and other masonry; fences
Medium-Low
A satin enamel sheen creates a pearl-like finish that's durable and dirt-resistant. It will also resist moisture, fading and stains.
Virtually all exterior surfaces
Medium-High
A semi-gloss enamel sheen is sleek and radiant with a hard, durable finish. It is formulated to withstand wear, and will also resist moisture, fading and stains.
Doors, trim and shutters; Exterior furniture
High
Hi-Gloss enamel sheen have a brilliant, shiny appearance and a durable, glass-like finish that allows dirt and grime to be wiped clean.
High-use surfaces
High
- Free Same-Day, Next-Day Delivery*
- Call, Text, or Email Your Paint Order
- Will Call & Schedule Deliveries
- Custom Color Matching
- Product & Record Order Management
- Expert Paint Knowledge
- Free Same-Day, Next-Day Delivery*
- Call, Text, or Email Your Paint Order
- Will Call & Schedule Deliveries
- Custom Color Matching
- Product & Record Order Management
- Expert Paint Knowledge
- Get 10%-20% back in quarterly rewards on BEHR® Products when you join Home Depot's Pro Xtra™ loyalty program
- Call, Text or E-mail your orders to your dedicated BEHR PRO Paint Specialist
- Arrange will call & Schedule Deliveries for pick-up at your Home Depot location or for delivery to you
