PREMIUM PLUS^® Interior/Exterior Hi-Gloss Enamel No. 8050

Preparation

• Use on properly prepared and cleaned coated and uncoated Exterior surfaces.
• Countersink nailheads, fill and sand smooth.
• Remove rust, loose or peeling paint. Repair imperfections and sand smooth.
• Wash off dirt, grease and chalk with detergent and/or powerwash.
• Remove mildew stains with a mildew stain removing product.
• Clean and sand new or weathered wood.
• Scuff sand or degloss smooth or glossy surfaces.
• Scuff sand or etch metals.
• Rinse and allow to dry.
• Caulk windows, doors and other openings.
• Allow new stucco, plaster and masonry to cure for 30 days before painting.

Prime†

• Use BEHR PREMIUM PLUS® Paint as a primer over properly prepared coated or uncoated surfaces
• For stain-blocking, painting over woods with tannins, or over oil-based or glossy surfaces, prime with a product such as BEHR® NO. 436 Exterior Multi-Surface Primer & Sealer.
• For drastic colour changes or when applying deep colours denoted with a dagger (†) on the colour chip, apply a custom tinted primer if needed.
• Prime all metal surfaces before painting.

Application

• Apply product on dry substrates when air and surface temperatures are between 2°-32°C and will remain between 2°-32°C for at least 4 hours after applying.
• Do not paint when rain or heavy condensation is expected.
• Stir paint occasionally. Intermix containers of same product to ensure colour and sheen uniformity.
• Use a high quality 10-13 mm nap roller cover, nylon/polyester brush or airless sprayer (.015-.021" spray tip, 60 mesh filter).
• Do not thin if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a rate of no more than 250 mL per 3.79 L.
• Certain colours may require additional coats for complete hide. On heavy stains and woods that contain tannins, allow 12-16 hours of dry time between coats.
• Cooler temperatures or higher humidity may prolong drying time. After 4 weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent.
• After 4 weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent.
• Dry paint film is mildew resistant. When applying to vinyl, colour choice must be the same colour or lighter than the existing colour. Do not use on floors.

Disposal

• For disposal of empty containers, unused paint and soiled rags, contact your household refuse collection service.

To consult with a Behr Certified Coatings Professional, call 1-800-661-1591.