Where Not to Use

DO NOT use on vertical surfaces or areas subject to hydrostatic pressure. NOT for industrial use or areas subject to forklifts. 

Preparation†

PROPER SURFACE PREPARATION IS REQUIRED.

• All surfaces must be clean, sound, dry and free of any dirt, oil and grease.

For Uncoated Concrete or Masonry:

• For a painted surface in sound condition, use a product to clean and prepare the surface.
• If the coating is failing or peeling, use a paint stripper to remove old coating or scrape/sand down to a sound concrete surface.
• Scuff sand glossy surfaces.
• Clean and spot etch any exposed concrete.
• Remove all dust with a damp cloth, allow to dry.

Application

• DO NOT THIN. Intermix all cans of the same product to ensure colour uniformity.
• Stir before and occasionally during application.
• Use product when air and surface temperatures are between 10-32° C.
• Apply to dry concrete. Do not apply if rain or heavy dew is expected within 24 hours.
• Do not apply in direct sunlight.
• Tape off any adjacent areas and apply to the edges using a nylon/polyester brush.
• For hairline cracks up to 2 mm, completely fill in with coating using a brush and allow to dry completely prior to roller application.
• Apply an even first coat using a 6 mm adhesive roller cover or nylon/polyester brush.
• NOTE: The first coat will act as the base coat and it will not completely cover the surface by design. Avoid over application on the first coat.
• Apply from a roller tray or pour directly from the container
• NOTE: Pouring can help spread the coating quickly however it may reduce the overall spread rate.
• Work in areas approximately 1 m x 1 m.
• Pour a circular (pancake style) shape with a 25 cm diameter of the working area.
• Spread from the center outwards, rolling in multiple directions to evenly distribute.
• For long, narrow areas, pour a strip about 8 -12 cm across the surface.
• Apply moderate pressure to the roller to push the coating outwards and even out the surface.
• Work quickly and overlap the previously coated areas to ensure full coverage.
• Avoid regular patterns and knock down hard edges using the roller.
• Allow first coat to dry then apply second coat in the same method as the first coat.
• While two coats are necessary, additional coats may help hide previous surface imperfections or cover over contrasting colours.
• For large projects, consider using a texture sprayer with a 4mm tip.
• Spray in 1.2 m x 1.2 m sections and back roll with 6 mm adhesive roller cover.

Dry Time

• Longer dry time required in cooler temperatures and in higher humidity.
• The floor may be subjected to light foot traffic after 24 hours.
• Allow 72 hours before subjecting surface to automotive tires, heavy foot traffic or repositioning furniture.
• Premature heavy traffic will cause paint failure requiring spot recoating.

Clean Up

• Soap & water clean-up.
• Wait at least 30 days before rinsing or cleaning.
• Use a mild detergent as needed.
• Abrasive cleaners and pressure-washers should be used carefully to avoid premature coating failure.

Disposal

• Properly dispose of all soiled rags.
• To recycle or properly dispose of product in your community, contact your household refuse collection service.

To consult with a Behr Company Representative, call 1-800-661-1591.